Woodcraft Underfork Front Stand Lifter Conversion Kit – Pin Style
$24.99
*Additional shipping charges apply for this item.
*Important* This is an awesome design for a front stand that is much more stable for bikes like the Yamaha R3 and Ninja 400 with single calipers. However, the tips of the stand pins are a little too long to work with the 2019+ Yamaha R3 forks because they contact the axle and the axle cannot be removed while on the stand. Because we like the stand design so much, we took the time to grind the tips off of the pins so I could use this stand for my personal 2019 Yamaha R3. We don’t do this prior to shipping, but recommend that you do so if you have a 2019+ R3, or take it to a professional to have them ground to fit your 2019+ R3 and remove the axle. Again, these are NOT pre-ground for the 2019+ R3, do so at your own risk!
OZ Racing, BST, and most Marchesini aftermarket wheels use a different bolt pattern from OEM for rear sprockets. 5 bolts, 10.5mm diameter, on a 100mm bolt circle with 76mm center hub diameter. Use these sprockets instead.
*(Marchesini wheels for Yamaha R3 use OEM sprockets)
*These sprockets are special order only, no returns.
OZ Racing, BST, and most Marchesini aftermarket wheels use a different bolt pattern from OEM for rear sprockets. 5 bolts, 10.5mm diameter, on a 100mm bolt circle with 76mm center hub diameter. Use these sprockets instead.
*(Marchesini wheels for Yamaha R3 use OEM sprockets)
*These sprockets are special order only, no returns.
OZ Racing, BST, and most Marchesini aftermarket wheels use a different bolt pattern from OEM for rear sprockets. 5 bolts, 10.5mm diameter, on a 100mm bolt circle with 76mm center hub diameter. Use these sprockets instead.
*(Marchesini wheels for Yamaha R3 use OEM sprockets)
*These sprockets are special order only, no returns.
*Transmission undercutting is a service to modify your OEM transmission. You must remove your transmission and ship it to us for undercutting service. We will inspect all gears upon dis-assembly and let you know if any gears should be replaced before undercutting. New OEM spring clips may be required for re-assembly.
This simple and inexpensive OBD2 Scanner can read and reset check engine lights for modern ECUs and is helpful for clearing check engine light codes once emissions systems are bypassed and/or disabled in the ECU via our ECU flash.
You can use this scanner with the FTECU OBD2 Diagnostic Harness to read and clear check engine lights in your Kawasaki Ninja 400.
*Important* This is an awesome design for a front stand that is much more stable for bikes like the Yamaha R3 and Ninja 400 with single calipers. However, the tips of the stand pins are a little too long to work with the 2019 Yamaha R3 forks because they contact the axle and the axle cannot be removed while on the stand. Because I like the stand design so much, I took the time to grind the tips off of the pins so I could use this stand for my personal 2019 Yamaha R3.
